Toyota is launching another engine-related recall for its third-generation Tundra. Some 62,000 trucks in the U.S. and another 6,835 in Canada (approximately, says Toyota Canada) are being called in for service due to a manufacturing defect that could cause a camshaft to snap while driving.
The campaign, announced by Toyota Canada last Friday the 13th, covers non-hybrid 2022–2023 and 2025–2026 Toyota Tundra models equipped with the gas-only 3.4L twin-turbo V6 engine (V35A-FTS). Not included in the recall is the 2024 Tundra. Same goes for Tundra hybrid models, Sequoia SUVs fitted with the same engine and the incoming 2027 Tundra.
The problem
According to Toyota Canada, the issue stems from a specific production lot of camshafts supplied by a single (unnamed) parts manufacturer and installed on bank one of the V6 engine. Because the camshaft controls the opening and closing of the engine's valves, an improperly manufactured unit could fracture in operation, resulting in sudden engine failure and a complete loss of motive power. At highway speeds, that sudden loss of propulsion increases the risk of a crash.
While nearly 7,000 Canadian trucks are being called in, Toyota estimates that only about 300 defective camshafts from the suspect batch were actually installed across the affected vehicles. The vast majority of inspected trucks will thus not require parts replacement and can be just sent on their way after being inspected.
Note that this campaign is separate from Toyota’s earlier, high-profile Tundra recall, which was announced in 2024 and expanded in May 2026 to cover roughly 17,000 trucks in Canada. That recall addressed machining debris left in the crankcase that could damage crankshaft bearings.
Toyota is not advising owners to stop driving their vehicles, though drivers who notice unusual engine noises, vibrations or a loss of power should pull over safely and contact a dealer.
The solution
Official notification letters will be mailed to affected owners by mid-January 2027. Dealership technicians will inspect the camshaft and replace it free of charge if it originates from the affected production lot.
Until those letters start to arrive, owners of Tundras falling within the scope of the recall can check whether their truck is involved by entering their Vehicle Identification Number (VIN) at Toyota.ca/recall or by calling Toyota’s Customer Interaction Centre at 1-888-869-6828.





